Pre-Order
My cart:
0
Your cart is currently empty.
Creative Ceramics Moulds for Fusing, Slumping & Casting
This is a general template for creating fan shaped wall pieces or wall lamps.
A creative idea could be to try to cut the glass diameter smaller than the mould or only use a section to suggest a half open fan.
Recommended Firing Chart
Please Read: This firing recommendation has been calculated for use with Bullseye Glass of average viscosity with an even thickness of 4 - 6 mm. The chart shown below is also based on the assumption that you are using a top fired kiln, e.g. Paragon GL22, GL24, BVD Flat bed kilns etc. If you are using a side firing kiln you must allow more time in the first ramp.
958.049
4424 2.000000
Related Products (There are 3 other products in the same category)
Pre-Order